Automatically Setting The Remote Control - Philips SBC RU 530/87U Instrucciones De Manejo

XP SBC RU 530/87.3 09-02-2004 15:31 Pagina 7

Automatically setting the remote control

If you cannot find the right code for your brand device,
the remote control can automatically search for the right code.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU530 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
• If the device is a video recorder,
insert a tape and start playback.
2
Then keep keys 1 and 3 on the RU530
pressed simultaneously for three seconds,
until the green light under TV in the selector
window flashes twice and then remains lit.
3
Press the Standby key of the RU530 briefly.
– The RU530 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the green light under
TV in the selector window lights up.
4
When your TV switches off (stand-by),
you press the Standby key of the RU530
twice within 1 second, to confirm.
– The RU530 has now found a code that
works on your TV.
5
Check if you can operate all functions on your
TV with the RU530.
• If this is not the case, you can redo the automatic setting.
The RU530 will then search for a code that perhaps works
better.
– After the RU530 has run through all the known codes,
the search will stop automatically and the green light will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
For VCR this time is 2 minutes and for SAT 4 minutes.
Instructions for use
1 2 3
4 5 6
7 8 9
0
SHIFT
TV VCR SAT
TV VCR SAT
2x
TV VCR SAT
7