Idiomas disponibles
Idiomas disponibles
88885100407xxxxxxxx#. To delete the phone number on position 3 send SMS: 888853#
or delete the number from
Set SMS warnings phone numbers by choosing „SMS warnings" app option or by
Ÿ
sending a SMS to the main unit phone number containing: programming password +
[57]...[59] + phone number + # .
Delete a SMS warning phone number by choosing „SMS warnings" app option or by
Ÿ
sending a SMS to the main unit phone number containing: programming password +
[57]...[59] + # .
Ÿ
For example:
88885700407xxxxxxxx#. To delete the phone number on position 9 send SMS:
888859# or delete the number from
Check programmed phone numbers: send SMS containing: programming password
Ÿ
+ [701] + #.
Add remote controls
In the status of disarm, press [SET] button lightly, the host will make a short
beep, the 7 blue LED light will be on and then voice prompts "enter setup, remote
controller coding", entering the state of remote controller coding; Take one remote
controller which need to pair the code, and press any key, it will send a signal to the host;
When the host receive the signal, the voice prompts"coding completed" and store the
information. After that the voice prompts "remote controller coding". You can pair the
second remote controller right now.
Caution: The host can pair at most 8 remote controllers. The method of pairing other
remote controls is the same.
NOTE: If no button is pressed for 30 sec the system will exit programing mode.
Delete remote controls
In the status of disarm, press [SET] button lightly, the host will make a short
beep, the 7 blue LED light will be on and then voice prompts "enter setup, remote
controller coding". Then press [SET] button for 3 seconds, the voice prompts "delete
completed". All the remote controllers will be deleted.
Add detectors
In the status of disarm, press [SET] button lightly, the host will make a short
beep, the 7 blue LED light will be on and voice prompts "enter setup, remote controller
coding". And then press [SET] button lightly again, the first blue LED light will be on and
the voice prompts "detector coding". The host will enter in the state of detector coding of
defense zone 1. After you trigger the detector, the detector will send a signal to the host;
When the host receives the signal, the voice prompts"Coding completed". After that
voice prompts "The detector coding" again. You can pair the second detector right now.
Totally 10 detectors can be paired. Press set button again, the second blue LED light will
be on and enter the state of detector coding of defense zone 2. The method of adding
detectors of second and other defense zones is same as above.
Cautions:
Each defense zone can pair at most 10 detectors. The panel will sound "zone is full"
Ÿ
„Voice warnings" app option
to set the phone number 07xx.xxx.xxx on position 7 send SMS:
then hit send.
„SMS warnings" app option
16
16
EN
then hit send.
