Tabla De Contenido; Transportation - McQuay C Serie Manual De Instalación

- Outline And Dimensions
- Electrical Wiring Diagram
- Isolator Diagram
- Transportation
- Installation Location
- Unit Installation
- Physical Data
- Water Piping and Fitting
- Electrical And Wiring
- Electrical Data
Please take note of the following important points when installing.
• Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it may cause fire ignition.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.
• Sharp edges and aluminium fin coil surface are potential which may cause injury hazards.
Avoid from being in contact with these locations.
• Use spreader bars or forklift to lift the unit to avoid damage to the panels. Figure 1 provides the dimensions of the crate for
lifting. Avoid violent movements. Do not remove crate until it is at its final location.
If necessary, use crane for unit above 11kW. Check that the hanger belts are able to support the unit. Refer to the weight
of the unit given in the specification manual for assistance.
Ensure that the hanger belts are not touching the coil, top panel and front panel. Use hosting bracket (provided along with
this manual) as shown in Figure 2. Lift the unit slightly to make sure it is balance before placing it in location. Never swing
or roll the unit.
INDEX
page i-ii
page iii-viii
page ix-x
page 1
page 2
page 4
page 5
page 7
page 7
page 8
! ! ! ! ! CAUTION

TRANSPORTATION

577
- Recommended Fuse And Cable Sizes
- Water Piping System Setup
- Refrigerant Circuit
- Special Precautions When Dealing With R407C Unit page 11
- Control Operation Guide
- Servicing And Maintenance
- Troubleshooting
- Fan Speed Controller (Optional)
- Isolator Switch Field Installation
1-1
577
Figure 1
page 8
page 11
page 11
page 12
page 13
page 14
page 15
page 15