Finalize The Installation - Haier QFT15 Serie Manual Del Propietário

INSTALLING THE STACK BRACKET KIT
1 INSTALL BRACKET TO WASHER
A. Remove washer top cap screw from the rear left.
Align left bracket holes with top cap screw hole on
rear left of the unit and replace screw.
NOTE: Leave screws loose so dryer hole alignment
will be easier.
B. Drive next screw through the bracket into the rear
of the washer.
C. Repeat the above steps with the right side.
Washer
Top
2 INSTALL DRYER AND BRACKET ON
DRYER
Disconnect power before installing.
WARNING
Failure to do so could result in
serious injury or death.
WARNING
Failure to do so may result in back or other injury, or
property damage.
• Use two or more people to install dryer.
• Avoid tipping and rupture of utility services.
• Dryer must be securely attached to the washer.
• DO NOT place the washer on top of the dryer.
A. Lift the dryer on top of the washer. Protect the
washer control panel with cardboard or other
protection. Be sure to lift the dryer high enough to
clear the washer control panel.
B. Align the holes in the bracket with the holes in the
back of the dryer. Using a Phillips screwdriver, attach
the 2 #8 x 1/2" tapping screws.
49-3000193
INSTALLATION INSTRUCTIONS
Short screws into
brackets and washer
- Excessive Weight
Hazard
2 INSTALL DRYER AND BRACKET ON
DRYER (CONT.)
C. Tighten the dryer bracket screws; then tighten all
stacking kit screws.
Long screws into
brackets and dryer
3

FINALIZE THE INSTALLATION

Do not push on the dryer once
CAUTION
installed to top of the washer.
Pushing on the dryer may result in pinched fingers.
A. Refer to the washer Installation Instructions to
complete the washer installation.
B. Refer to the dryer Installation Instructions to
complete the dryer installation.
C. Carefully slide or walk the stacked washer and dryer
into place. Use felt pads or other sliding device to
assist moving and to protect flooring.
Dryer
Place
hands
here
Washer
Place
hands
here
21