Programming Functions - Dometic GROUP WAECO WPS900F Manual Del Usuario

WPS900F/WPS910

Programming functions

You can also set the function for the front sensors by programming it once,
using the following method, among others (see fig. i):
I
NOTE
The default settings are printed in bold in the table fig. i.
 Parameter 1: Speed signal/time-out front sensors (function 13 – 16)
Default setting: speed-dependent
Function 13 (speed-dependent) is set by default. If there is no speed sig-
nal available which is compatible, you have the alternative of using the
time-out to deactivate the front parking aid. Once activated, the pro-
grammed time period starts counting down.
If there is an obstacle in the detection range when the time period is over,
the front parking aid remains active. Only when no obstacle is detected
for more than 5 s will the front parking aid shut down.
 Parameter 2: Duration of the front sensor signal
Default setting: 1 sec.
 Parameter 3: Choose the speed signal source
Default setting: Control unit
 Parameter 4: Detection range of the inner front sensors
Default setting: 80 cm
 Parameter 5: Detection range of the inner rear sensors
Default setting: 160 cm
 Parameter 6: Detection range of the outer front sensors
Default setting: 55 cm
 Parameter 7: Detection range of the outer rear sensors
Default setting: 55 cm
 Parameter 8: Stop zone for front sensors
Default setting: Corner sensors = 25 cm, middle sensors = 35 cm
 Parameter 9: Stop zone for rear sensors
Default setting: 35 cm
 Parameter 10: Volume of warning tones for front sensors
Default setting: High
 Parameter 11: Volume of warning tones for rear sensors
Default setting: High
EN
Setting the system
39