Renfert Basic eco Guia De Inicio Rapido página 7

Introduction
This Quick Start Guide contains instructions on the operation of the product and relevant safety informa-
tion. Detailed information on the product can be found in the operating instructions which are available for
download on our website at www.renfert.com.
Employed symbols
In these instructions or on the unit itself you will find symbols which have the following meaning:
Danger
This indicates an imminent risk of injury. Please observe the accompanying documents!
Electrical hazard
There is a risk of electrical shock.
Attention
Failure to observe the associated information can result in damage to the unit.
Note
The operating instructions contain useful information to make handling easier.
Attention!
Wear eye protection.
The unit complies with the relevant EC guidelines.
The unit is subject to the EC guidelines 2002/96/EG (WEEE Directive).
Other symbols are explained as they occur.
Safety
Intended use
The Basic line of sandblasting units are designed for use in dental laboratories to remove investment res-
idues, oxides on cast objects, and for surface treatment. Other areas of use also include divesting press
ceramic or sandblasting porcelain occlusal surfaces.
Improper use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
Hazard and warning information
General information
► If the device is not used in compliance with the supplied instructions, the safety of the device can
no longer be guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system. Any
necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical, Electronic and Information Technology).
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing. Devices with damaged
connection cables, tubes or housing parts or other defects must not be operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure the
device is not used. Send the device for repair!
► Only operate the device under supervision.
► Please observe the national accident prevention regulations!
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support area.
- 1 -
EN