How To Use With Vacuum Bottle Stoppers; How To Impulse Seal - Excalibur EPV15 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

HOW TO USE WITH VACUUM BOTTLE STOPPERS

EPV15 can vacuum bottle with bottle stoppers. If you cannot finish a bottle of wine at one
time, or you need to preserve a bottle of non-carbonic acid drink, edible oil, a bottle of juice
or any liquid else that is stored in a bottle, you can use the EPV15 to vacuum the bottle with
a bottle stopper.
1. Plug the vacuum bottle stopper to the bottle. Please allow at least 2.5cm distance
between the bottom of the stopper and the surface of the liquid.
2. Connect the hose to the accessory port of the machine and the other end to the port of
the bottle stopper.
3. Press "Accessory" button, the machine starts to vacuum.
** Press On/Off button to stop the machine's all working processes.
4. After the vacuum cycle is complete, the machine will stop automatically.
Remove the hose from the stopper.
5. Put the bottle vertically in a plane surface. Make sure the liquid does not touch the stopper.
6. Simply remove the stopper if you want to open the bottle.

HOW TO IMPULSE SEAL

Sometimes things do not need to vacuum seal, they only need to seal. So Impulse Seal mode
is added in this machine. When enter into the Impulse Seal mode, you don't need to press
any button but only open and close the lid to seal the bag.
1. Press "+""-"button to set the seal time;
2. Press Impulse Seal button, the Impulse Seal light is on. The machine enters into Impulse Seal
mode (if the lid is close, LED shows C; if the lid is open, LED blinks showing the seal time);
3. Put the bag mouth across the seal wire and into the chamber. Close and press the lid,
the machine detects that the lid is close then enter into Seal mode. The digits in LED
counts down from preset seal time to 0. The machine will release air and lid, then
beep when the process is finished.
** Press On/Off button to stop the machine's all working processes. **
4. Open the lid, take out the bag and check if the sealing is good.
5. Repeat the above 3 and 4 to seal other bags. Or press On/Off button to exit this mode.
(Note: If many bags need to be Impulse Seal, adjust/shorten the seal time when
needed to avoid overheated or melting the bag)
10
Tabla de contenido

Solución de problemas

loading

Tabla de contenido