Safety Instructions For Led Lights; Safety Instructions For Batteries; Appliance-Specific Safety Instructions For Transformers; Operation - Parkside PMGS 12 D3 Traducción Del Manual De Instrucciones Original

Safety instructions for LED lights

WARNING! RISK OF INJURY TO THE
EYES!
■
Never aim the light directly at people or ani-
mals and never look directly into the light
beam of the LED light.

Safety instructions for batteries

CAUTION!
■ Do not leave used batteries in the device as
even leak-protected batteries corrode and
chemicals can be released which could dam-
age your health or destroy the appliance. Do
not leave batteries lying around unattended.
They could be swallowed by children or
pets. In case of swallowing, consult a doctor
immediately.
■ If you do not plan to use the appliance for
an extended period, remove the batteries to
prevent leakages.
■ Leaking or damaged batteries can cause skin
irritations if touched. If this occurs, wear suit-
able gloves.
■ Ensure that batteries cannot be short-circuited.
Do not throw batteries into a fire.
■ Do not attempt to recharge non-rechargeable
batteries. There is a risk of explosion!
Appliance-specific safety instructions
for transformers
Only for indoor use!
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity.
■ Wear safety goggles and a protective dust
mask!
│ GB │ IE
■ 22
■ Safety transformer fail-safe
■ Thermal link

Operation

■ Never use the appliance for other purposes
and only original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.

Changing the batteries

♦ Make sure that the LED light is turned off. Remove
the three screws from the rear of the grip ring
with LED .
♦ Replace the used batteries in the appliance
with new batteries of the same type (button
cell LR41). Note polarity when installing new
batteries.
♦ Close the battery compartment again by replacing
the three screws.
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place.
♦ Undo the tensioning nut
using the combination key
♦ Remove any attached tool.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate
collet chuck for the tool shaft.
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination key
and hold it down.
until the lock clicks
from the thread
.
and hold it down.
into the thread insert
tight with the
.
PMGS 12 D3