System Components; System Display - BENDIX Activa Fusion Manual Del Operador

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

The main components used in the Bendix

ESP

Controller; the Bendix

Mobileye

System‑on‑Chip EyeQ

algorithms); the Bendix

SafetyDirect

by Bendix CVS Processor; and the vehicle's telematics system.

Bendix

Radar

Sensor

SafetyDirect

by Bendix CVS

Processor

The Bendix Fusion system locates and tracks moving and stationary vehicles.

The radar is located at the front of your vehicle – either on the bumper or

just behind it on a cross‑member. When located behind the bumper, in some

cases the unit may also be behind a protective covering that allows the radar

signal to pass through. The camera is located on the windshield inside the

wiper pattern.

The Bendix Fusion system radar is pre‑aligned at the factory and no adjustment

should be needed. If the radar becomes misaligned – or any other system

problem is detected – a message (or light) on the dash lets you know that

service is needed.

With a range of approximately 328 ft (100 m), the system reacts ONLY to

vehicles moving in the same direction as you. (The system DOES NOT respond

to side‑to‑side moving traffic or oncoming traffic.)

Driver information about the Fusion system is either fully integrated into the

vehicle dashboard, or uses the Bendix DIU. Although the system functions the

same, how the alerts are displayed to you can be different. See the System

Features section of this manual for more detailed information about the alerts.