Operating Instructions
RECOMMENDED HOOKUP
Please refer to Air Tool Set Up
(IN170102AV) for system hookup
instructions.
1. The air com-
pressor must
be able to
maintain a
minimum of
50 psi when
the nailer is
being used. An inadequate air sup-
ply can cause a loss of power and
inconsistent driving.
2. An oiler can be used
to provide oil circula-
tion through the nail-
er. A filter can be
used to remove liquid
and solid impurities
which can rust or
"gum up" internal parts of the
nailer.
3. Use 3/8" air
hoses with a
150 PSI WP
minimum
working pres-
sure of 150
psi. Use 1/2" air hoses for 50' run or
longer. For better performance,
install a 3/8" quick plug (1/4" NPT
threads) with an inside diameter of
.315" (8mm) on the nailer and a
3/8" quick coupler on the air hose.
4. Use a pressure regulator on the
compressor, with an operating pres-
sure of 0 -125 psi. A pressure regula-
tor is required to control the oper-
ating pressure of the nailer
between 50 and 125 psi.
Driving a Fastener
1. Hold tool with
nose pointed
toward work sur-
face.
50 psi
2. Align fastener
Min.
and tool in the
location where
125 psi
fastener is to be
Max.
driven.
3. Push gently
against nail head
to drive fastener.
4. Continue to apply
pressure until fas-
tener is driven
completely or until reaching desired
penetration.
Adjusting the Nail
Penetration
Nail penetration can be adjusted on
the PN0090 Nailer by installing or
removing spacers (Campbell Hausfeld
part number SV348700AV - sold sepa-
3/8" I.D.
rately) located in the nose assembly of
the tool. Adding or removing spacers
changes the nail penetration by 1/32"
per spacer. No more than three spacers
should be installed.
1. Disconnect air supply
from tool.
2. Remove the nose
from the tool.
3. Remove nail guide
and spring assembly
from tool.
4. Add or remove spac-
ers to achieve
desired nail penetra-
tion.
5. Replace nail guide
and spring assembly
on tool.
6. Replace nose over
nail guide and
secure tightly in
place. Nose assembly
should be secured
with a thread-lock-
ing compound prior to assembly.
TECHNICAL SUPPORT
Should you have any questions regard-
ing the operation or repair of this nail-
er, please call our Nailer Hotline at
1-800-543-6400 for assistance. If you are
calling from Ohio or outside of the con-
tinental United States, please call col-
lect, 1-513-367-1182.
Replacement Parts
replacement parts. Never substitute
parts. Do not use modified parts or
parts which will not give equivalent
performance to the original equipment.
Tool performance, safety and durability
could be reduced. When ordering parts,
specify by part number.
Nailer Repair
Nailer repairs must be performed by
qualified and experienced service peo-
ple ONLY.
Assembly Procedure for Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil or equivalent, must be
added through the air line before
testing.
3
Model PN0090
Use only genuine
WARNING
!
Campbell Hausfeld
