Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FocusPRO
®
Thermostat Installation Guide
4
Mount thermostat
Detach wallplate
Replacing system components
To replace a thermostat, install batteries and follow the procedures on page
2 to link it to the wireless network. If necessary, modify settings as needed
(see tables on pages 4-6).
After installing a new EIM or zone panel, you must re-set the thermostat to
communicate with the new equipment, as described below:
1 Press and hold the thermostat
2 Press
twice to display Function 39 (wireless setup).
BACK
▼
3 Press
to change Function 39 setting to 0 (disconnect from system).
4 Follow the procedures on page 2 to relink to system.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
http://yourhome.honeywell.com
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
69-2092EFS-01
06-2008
© 2008 Honeywell International Inc.
® U.S. Registered Trademark.
Mount wallplate and thermostat
▲
and
buttons for 3 seconds.
FAN
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Scarborough, Ontario M1V 4Z9
8
Tabla de contenido
