Function: Printing In "Solder" Mode; Power-Saving Mode - DENTAURUM Master 3000 Manual Del Usuario

7.3

Function: Printing in "Solder" mode

1. Connect the printer to the welding unit as described in section 7.1.
2. Press pad  on the welding unit to select "Soldering" mode. The LCD display now shows
"Soldering" and the last figure set, e. g. 50.
3. Press pad  on the welding unit. The yellow LCD lights up. All processes and soldering settings
are now stored in the printer's memory. If no printer is connected, "CHECK PRINTER" appears
in the display.
4. After ending the soldering work, again press pad  on the welding unit. The LCD goes off and
the data is transferred to the report printer.
5. The following parameters are now printed on the report:
!
Note:
• F or more detailed information on printer functions, refer to the operating instructions for
the report printer.
• T he printer outlet  of the welding unit is intended only for the report printer described
(REF 090-581-00). Connecting printers or units of any other kind may cause irreparable
damage to the electronic components of the welding unit.
8.

Power-saving mode

The welding unit is fitted with a power-saving mode. If the unit remains unused for longer than
10 minutes when switched on, a number of important functions are switched off automatically.
The signal "STANDBY" appears in the display. This function saves power. As soon as a pad on the
operating panel or the manual button  is pressed, the welding unit turns on again. The mode
previously in use appears in the display.
„Welding"
„Soldering"
master 3000  en
EN EN
46