Soldering With Hand Electrodes (Optional Accessory) - DENTAURUM Master 3000 Manual Del Usuario

6.2.2 Soldering with hand electrodes (optional accessory)

Procedure:
1. Turn the upper electrode head on the "click-stop" holder  one half turn (45°) to left or right.
!
When soldering, always wear safety goggles. If soldering takes too long, the
soldering carbon is damaged.



2. Push the plugs of the hand electrodes into the outlets  and .
3. Clamp the electrode REF 081-701-00 for holding the workpiece and clamp the soldering
carbon REF 081-601-00 into the clamping sleeve of the right and left hand electrode.
(cf. fig. below)
4. Turn power switch  to position "I".
5. Press key  to select the "Soldering" mode. The green LED  or h key lights up, when the
unit electronics are operational.
6. Clamp the tack-welded parts in the clamping electrode as close as possible to the soldering
point.
7. A pply flux when using solder in rods or in a roll, REF 380-604-50, REF 380-600-50 or
REF 380-704-50.
8. Place the tip of the soldering carbon as close as possible to the soldering point.
9. Proceed as below a) or b) depending on the type of solder used.
a) Press the foot switch. Apply the solder when the solder joint begins to turn red.
b) Press the foot switch until the solder has completely melted.
10. If the unit is no longer required, turn power switch  to position "0".
Hand electrode with
soldering carbon
S O L D E R I N G
5 0
Hand electrode with
clamping electrode

EN EN
master 3000  en
41