Soldering With "Click-Stop" Electrodes - DENTAURUM Master 3000 Manual Del Usuario

6.2.1 Soldering with the "click-stop" electrodes
First tack weld the parts together with a weld spot.
Procedure
1. Turn power switch  to position "I". The mode last set is displayed.



2. Press pad  to select the "Soldering" mode. The LCD display now shows "Soldering" and the
last figure set for soldering energy, e. g. 50.
3. Set the electrodes to combination A or B (cf. fig. below).
4. A pply flux to the section to be soldered and add the solder or apply universal silver soldering
paste (REF 380-804-50).
5. Set the desired heat intensity from 01 to 88 using the pad  or . The figure selected is
displayed in the LCD display . The setting is made in steps from 01 to 88. If one of the pads
 or  is pressed for longer than 4 sec the steps are changed faster.
6. Press the hand rest  down and place the workpiece between the electrodes.
7. Align the carbon electrode on the workpiece without applying pressure.
8. Press the manual button  or the foot switch until the solder is melted and the soldering
process finished.
i
Note: Please always use the carbon soldering electrode.
S O L D E R I N G
5 0

Electrode combination:

EN EN
A
B
master 3000  en
40