FR
RR
3. Prepare the Bath - Claw Feet
CAUTION: Risk of personal injury. Cast iron baths are extremely heavy. Obtain sufficient help to
carefully lift or move the bath.
With help, lift and position one end of the bath on blocks so the end of the bath is about 8" (203
mm) above the finished floor.
IMPORTANT! Each claw foot is marked to identify its correct location on the bath. Refer to the
illustration above.
Position the claw foot over the lug in the correct corresponding corner of the bath.
Thread the bolt and washer into the lug several turns. Do not tighten the bolt at this time.
Use your hand to press the claw foot flush against the bath surface. Use a 3/16" hex wrench to turn
in the setscrew until the claw foot holds flush against the bath wall by itself.
If the claw foot does not hold itself flush against the bath wall, loosen the bolt and washer slightly,
and continue turning in the setscrew.
Repeat the foot adjustment steps until the claw foot holds itself flush against the bath wall.
Once the foot holds itself flush against the bath wall, securely wrench-tighten the bolt.
Repeat this procedure for the other claw feet, carefully moving the blocks to raise the other end of
the bath.
With help, carefully remove the blocks.
Kohler Co.
FL
RL
5
1349045-2-A