Connecting And Charging - Braun Oral-B PROFESSIONAL PRECISION 5000 Guia Del Usuario

English
Important Information
• Your Oral-B Triaction/Precision 5000/5500 uses
an interactive wireless display. To avoid electro-
magnetic interference and/or compatibility
conflicts, deactivate the radio transmission
before using it in restricted surroundings,
such as aircrafts or specially marked areas in
hospitals. Deactivate radio transmission by
simultaneously pressing the on/off and mode
button for 3 seconds until the radio transmission
display (f) goes off. Follow the same procedure
to reactivate transmission again.
• Persons with pacemakers should always keep
the toothbrush more than six inches (15 centi-
meters) from the pacemaker while turned on.
Anytime you suspect interference is taking
place, deactivate the radio transmission of your
toothbrush.
Description
a Brush head
b Pressure sensor light
c On/off button
d Brushing mode button
e Handle
f Radio transmission display
g Charge indicator
h Charging unit (basic charger and brush head
compartment with protective cover)
i SmartGuide
j SmartGuide holder
k Wall mount
l Adhesive ring

Connecting and charging

Your toothbrush has a waterproof handle, is electri-
cally safe and designed for use in the bathroom.
• Plug the charger into an electrical outlet. For
voltage specifications refer to the bottom of the
charging unit.
• The flashing green lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is fully
charged, the lights turn off. A full charge can take
up to 24 hours and enables up to ten days of
regular brushing (twice a day, 2 minutes).
Note: After deep discharge, the green lights might
not flash immediately; it can take up to 10–15
minutes.
• If the rechargeable battery is low the red charge
indicator light is flashing for some seconds when
turning your toothbrush on/off.
If the rechargeable battery is empty the motor will
stop; it will need a 40-minute charge before you
can use it for a 2-minute brushing.
• For everyday use, the toothbrush handle can be
stored on the charging unit to maintain it at full
power. Overcharging is impossible. To maintain
the maximum capacity of the rechargeable battery,
unplug the charging unit and fully discharge the
handle with regular use at least every 6 months.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode. Deactivate this mode by removing the
compartment cover in the back (picture A, page 4)
and push the «set» or «h/min» button.
A flashing «12:00» indicates that you can now adjust
the clock time.
Note: If the SmartGuide display is blank before first
use (no active demonstration mode / no batteries
inserted) the batteries will need to be replaced/
inserted before continuing.
Batteries are supplied.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12h» or «24h» daytime
format. Push «set» to confirm your choice. Then
the hour digit starts flashing. Press the «h/min»
button until the right hour appears and confirm with
«set». Proceed same way to set both minute digits
(picture B, page 4).
7