PW3800
7.2
Extending the awning
Extending the awning using a hand crank
➤ Click the hand crank into the holder in the awning (fig. 2, page 3).
➤ Turn the hand crank until the awning is extended to the required position
(fig. 3, page 4).
➤ Turn the hand crank approx. a quarter of the way back to tighten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
➤ Remove the hand crank from the holder on the awning.
Extending the awning using a motor (optional)
I
NOTE
Only for operation with the remote control:
• When the vehicle is started, the awning retracts automatically. While
the vehicle is running, the awning is blocked and can not be
extended.
• The receiver beeps once when it is switched on.
• Operation of the remote control can be affected by interference if
another device is being used nearby on the same frequency.
• Keep the remote control in a safe place while you are driving. The
magnet in the holder is not designed for strong vibrations, such as
sudden braking.
➤ Press the button
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
EN
until the awning is extended to the required position.
Operating the awning
15