Behringer CRAVE Manual Del Usuario página 63

CRAVE Parameters Selection
Step 5: Parameter Selection Mode
(EN)
The parameters may be changed using the following procedure:
1. Press SHIFT+ HOLD/REST + 8 to enter the setting mode.
The LOCATION LED 1 will blink yellow.
2. Press <KYBD or STEP> to select pages 1 to 4. The yellow
LOCATION LED shows the current page:
3. Page 1 allows you to select the tempo input mode, 1 to 5.
(Please see Programming Tempo Input Modes, below)
4. Page 2 allows you to select the assign output mode,
1 to 16. (Please see Assignable Output Mode, below)
5. Page 3 allows you to select the clock type mode, 1 to 5.
(Please see Clock Type Modes, below)
6. Page 4 allows you to select the clock edge mode, 1 to 2.
(Please see Clock Edge Modes, below)
7. Press STEP switches 1 to 8 to select numeric values
from 1 to 8. The current value is indicated by a green
LOCATION LED.
8. To access values 9 to 16, press SHIFT + STEP switch 1 to 8.
The current value is shown by a red LOCATION LED.
9. Note: If a setting is on the same LED number as the current
page LED, then the LED will flash alternately between the
yellow page color and the green or red parameter color.
10. Press SHIFT + HOLD/REST + 8 to exit the setting mode,
and save any parameter changes.
11. More parameters can be changed using the Synthtool App.
Programming Tempo Input Modes:
1. 1PPS
2. 2PPQ
3. 24PPQN
4. 48PPQN
5. CV
Assignable Output Modes:
1. Sequencer Accent
2. Sequencer Clock
3. Sequencer Clock/2
4. Sequencer Clock/4
5. Sequencer Step Ramp
6. Sequencer Step Saw
7. Sequencer Step Triangle
8. Sequencer Step Random
9. Sequencer Step 1 Trigger Output
10. MIDI Velocity
11. MIDI Channel Pressure
12. MIDI Pitch Bend
13. MIDI CC1
14. MIDI CC2
15. MIDI CC4
16. MIDI CC7
Clock Type Modes:
1. INTERNAL
2. MIDI DIN
3. MIDI USB
4. EXTERNAL TRIGGER
5. AUTO (clock priority: TRIG > MIDI USB >
MIDI DIN > INTERNAL)
Clock Edge Modes:
1. Fall
2. Rise
63
Quick Start Guide