Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. 8
Garden hose
4. Attach garden hose to water supply (Fig. 9).
Fig. 9
Connect to water supply
Garden hose
m
WARNING!
Do not connect to potable water system.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING!
The intake water temperature must
not exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
m
CAUTION!
To prevent damage to the appliance, do not
allow it to operate dry. Before starting the appliance, make
sure that it has proper and stable supply of water.
5. Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet.
Operation
IMPORTANT!
This pressure washer is equipped with a
micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 10).
Fig. 10
Power light
indicator
GFCI
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
2. Position the washer as CLOSE as possible to the
water supply.
3. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 11).
Fig. 11
4. Turn the water supply tap on completely.
8
Reset
Tabla de contenido
