Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any moving parts.
u
Injuries caused by touching any hot parts.
u
Injuries caused when changing any parts or accessories.
u
Injuries caused by prolonged use of the appliance. When
u
using any appliance for prolonged periods ensure you
take regular breaks.
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on the appliance
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
R
Warning! Do not expose the appliance to rain or
high humidity.
Warning! Keep bystanders away.
O
Warning! Wear safety glasses or goggles when
operating this tool.
8
(Original instructions)
6
Warning! Wear a respirator or mask.
&
Warning! Use only non-flammable liquids.
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
When using the tool outdoors, only use extension cables
u
intended for outdoor use. A suitable rated Black & Decker
extension cable of up to 30 m can be used without loss of
power.
Electric safety can be further improved by using a high-
u
sensitivity 30 mA residual current device (RCD).
Features
This appliance includes some or all of the following features.
1. Plug and power cord
2. Spray trigger
3. Sprayer
4. Power unit
5. Sprayer release button
6. Side fill canister
7. Lid
8. Flow control knob
9. Flow indicator
10. Pattern select nozzle
11. Filter cover
12. Mixing bucket
13. Viscosity cup
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Attaching the side fill canister (fig. A)
The side fill canister is designed so it will only fit one way
round.
Align the side fill canister (6) below the pick up tube (15)
u
with the lid (7) to the left.
Push the side fill canister (6) firmly into place.
u
Tighten the locking ring (16) by turning it clockwise.
u
Tabla de contenido
