Adjusting The Pressure Plate; Maintenance And Cleaning; General Cleaning And Servicing; Waste Disposal And Environmental Protection - Deltafox DG-ESS 2844B Traducción Del Manual De Instrucciones Original

2. Remove the housing plate (7).
3. You can now remove the blo-
ckage in the appliance.
4. When replacing the housing
plate (7), make sure it is positi-
oned correctly. It is fixed based
on the blade shaft (27), pressure
plate pin (24a) and their uptakes
(25/26) on the back of the hou-
sing plate (7).
5. Screw the housing plate (7) and
the snap rings (
four hexagon socket screws.

Adjusting the pressure plate

You will recognise that the cutting system
has become worn when the shredding
material is only compressed, and comes
out in long chains.
The running-in process may require that
you initially readjust the pressure plate in
short intervals.
1. Switch on the equipment.
2. Turn the adjusting screw (
clockwise until you hear scraping
noises. Small aluminium shavings will
come out of the ejection chute.
Avoid unnecessary wear on the
pressure plate by not over-adjust-
ing.

Maintenance and cleaning

Leave all work not described
in this manual to an authorised
customer service centre. Only
use original parts.
Wear hand protection when work-
ing on the blade cylinder.

General cleaning and servicing

• Always keep the shredder, wheels
23) with the
• Always check that the shredder and
• Check the covers and guards for
• Keep the shredder in a dry place out
A 8) slowly
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a
recycling centre when you have finished
with them.
Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out into pure
materials and recycling can be imple-
mented. Ask your Service Center about
this.
Switch the shredder off, unplug it
form the mains, and wait for the
blade cylinder to come to a com-
plete stop before working on it.
Do not spray water onto the
shredder. Electric shock hazard.
and air vents clean. Use a brush or
cloth to clean it, avoid cleaners and
solvents.
especially the guards are not worn
down or damaged but firmly attached
before use. Check that the nuts, bolts
and screws are tight.
damage and improper attachment. If
necessary, change the components
of children's reach. Do not cover the
shredder in nylon bags, as moisture
may develop.
Machines do not belong with do-
mestic waste.
GB
31