Switching On And Off; General Working Instructions; Adjusting The Working Angle; Using The Device As Grass Shears/Shrub Shears - Deltafox DG-CGC 1080 Traducción Del Manual De Instrucciones Original

Attaching accessories
1. Place the grass cutting blade (12), the
shrub cutting blade (10) or the spray at-
tachment (13) onto the plug-in connector
(16) on the bottom side of the device
head (1).
2. Press the accessory into the direction
of the device head (1).
It will lock into place audibly.
Removing accessories:
3. Press the release buttons (8) on the
device head (1) and remove the ac-
cessories (10/12/13).

Switching on and off

1. If necessary, remove the blade guard
(9/11) before switching the device on.
2. To start the device, push the switch
lock (3) forwards and press the on/off
switch (5). Then release the switch lock
(3).
The equipment runs at top speed.
3. In order to switch off, let go of the on/
off switch (5).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come to a
complete standstill. Do not touch
the blades or slow them down be-
fore the moving parts have come
to a standstill.
General working
instructions
• Check the device before each use for
obvious defects such as loose, worn
or damaged parts.
• Comply with the device's maintenance
and cleaning instructions.

Adjusting the working angle

Tilting the device handgrip:
The device handgrip (4) features three
angles of inclination:
1. Operate the unlocking mechanism (6)
and tilt the device handgrip (4) to the
desired angle.
2. Release the unlocking mechanism (6)
so that the device handgrip (4) locks
into place.
Rotating the device head:
The device head (1) features 7 positions:
1. Pull the unlocking mechanism (7)
downwards and rotate the device head
(1) into the desired position.
2. Release the unlocking mechanism (7),
the device head (1) will lock into place.
Using the device as grass
shears/shrub shears
Ensure objects such as wire, me-
tallic parts, stones etc. do not enter
the blades while trimming. This can
cause damage to the cutting unit.
If the blades become jammed with
solid objects, turn the device off im-
mediately.
• Ensure that the screws in the blade
bar are firmly in place.
• Only use sharp blades to ensure good
trimming performance and to protect
the device and rechargeable battery.
• Do not overload the device while wor-
king to such an extent that it comes to
a standstill.
GB
69