Front Panel Description - RS Pro RS-128M Manual De Instrucciones

Pinless Moisture Meter/ English

4.Front Panel Description

1-Moisture Sensor
2-LCD Display
3-MEAS Button
4-UP/Backlighting Button
5-ALARM SET Button
6-DOWN Button
7-0N/0FF Button
8-Battery Cover
5.lndicator
1-Low battery indication
2-Data hold symbol
3-Current moisture value
4-DRY status symbol
5-RISK status symbol
6-WET status symbol
7-MAX symbol
8-MAX moisture value
9-MIN symbol
10-MIN moisture value
6.0peration
Turn the Meter ON by pressing the button . Press the
MEAS button to start measuring. User press MEAS
button for the first time when the meter is turn on.
NOTE: hold the meter up so that the ball sensor is
in the air, not covered by your hand or any surface
2
01/12/2017 Version No. 001
Pinless Moisture Meter/ English
or object for 8 to10cm distance. The LCD will
display"CAL" indication and then the moisture value
display in LCD. The value must be below 0.5. If not,
please turn meter on again and repeat the operation.
Press the MEAS button again, the moisture
measurement shall latch on the Display for 30 sec.
HOLD symbol will be displayed. After 30 seconds, the
meter will Auto turn off.
Note: when you first turn the meter on, you must
calibrate once. If you move the meter from one place to
another, you must calibrate again.
7. Alarm Set Mode
By pressing the SET buton, you will enter the alarm
set mode. If the meter is already in data hold mode, the
"RISK" icon appears on the LCD and you can use the
UP and DOWN button to adjust the threshold.
Pressing the SET button will save the alarm seting. If
the "WET" icon appears on the LCD, you can use the
UP and DOWN button to adjust the threshold.
Pressing the SET button will save the alarm seting.
If the moisture measurement is higher than the RISK
alarm setting, it will beep once every 2 seconds If
the Moisture measurement exceeded the WET alarm
setting, it will beep four times every 1 second.
Note: The RISK value can adjust 0 to 50. The default
value is 30.
01/12/2017 Version No. 001
3