Electric Connections - RIB Normal Manual De Instrucciones

G G
B B

ELECTRIC CONNECTIONS

S
2 - MICROSWITCHES FOR CONTROL UNIT SETTINGS
Dip1 - For future use
Dip2 - Flasher
ON - fixed output, use flasher unit with card
ACG7010.
OFF - flasher output, use diamond line flasher unit ACG7050
Dip3 - Photocell
ON - stops movement during opening and closing
OFF - stops movement during closing only
Dip4 - Operation mode
ON - park mode
OFF - normal operation
Dip5 - Standby time prior to automatic closing (max. 5 min.)
ON - enabled
OFF - disabled
Dip6
ON - Heater card control (Heater for EUROBAR v.07) code
ACQ9097
OFF - Magnet control (code ACG8070 - ACG8073)
To manage the Heater and the Magnet read carefully the specific
manuals.
S3 - RESET
Each time the position of dipswitches is changed, loop S3 for at
least one second or the board will not accept the new settings
(also possible using a screwdriver).
J1 TERMINAL BOARD
NL 1 - 230V 50/60 Hz power supply
J2 CONNECTOR
Via an optional card (Relay card 1 code no. ACQ9075) this connector
powers a garage light with a time setting between 1 second and 3
minutes (max. 40 W).
Otherwise the connector can power an optional card to control an
electromagnet (supplied with column with magnet set code no.
ACG8070).
For information regarding the auxiliary cards, request specific
installation instructions.
J3 TERMINAL BOARD
L/L - 230 V ac electronic flasher unit power supply
U - Motor common
V/W - Motor inverters
J4 TERMINAL BOARD
K-OUT - N.O. contact; in normal operation mode operates as a
sinusoidal pulse (performs commands OPEN-STOP-
CLOSE-STOP...); in park mode enables closing 1 second
after vehicle transit.
IN-PARK - N.O. contact; in park mode, if connected to a magnetic
sensor or photocell, it indicates the presence of a vehicle on
approach to entry.
9 - Open pushbutton (N.O.)
11 - Close pushbutton (N.O.)
8 - Contact common
J5 TERMINAL BOARD
Terminals for connection of antenna coax cable (type RG58-52)
N.B. Ensure that the earth does not touch the central wire on the
cable as this will restrict transmitters range.
J6 TERMINAL BOARD
10 - Photocells and strips contact (N.C.)
6