Standard Compliance; Storage; After Usage; Introduction - Tripp-Lite SmartOnline SUINT1000XLCD El Manual Del Propietario

1. Important Safety Warnings

1.5 Standard Compliance

• CE
• EN 62040-1
• EN 62040-2 Category C2

1.6 Storage

Prior to installation
If the UPS needs to be stored prior to installation, it should be placed in a dry area. The allowable storage temperature is
between -15°C and 50°C.

After usage

Press the OFF button, make sure the UPS is shut down, disconnect the UPS from the utility power, remove all equipment
from the UPS, and store the UPS in a dry and well-ventilated area at a temperature between -15°C and 50°C. Idle batteries
must be recharged fully approximately every three months if the UPS needs to be stored for an extended period of time. The
charging time must not be less than 24 hours each time.
Note: After storage and before start-up of the UPS, allow the UPS to adjust to room temperature (20° to 25°C) for at least one hour to avoid
moisture condensation inside the UPS.

2. Introduction

2.1 General Overview

Tripp Lite's SUINT-Series UPS is a VFI (voltage and frequency independent) true on-line double-conversion UPS, providing
reliable and consistent sine-wave quality power to your electronic equipment. Designed to the highest quality with modern
IGBT technology, SUINT-Series UPS systems delivers a secure, reliable and uninterrupted supply of clean power to your critical
loads.
Developed with a variety of ratings and a compact footprint, the SUINT-Series delivers a high-output power factor and high
operating efficiency, providing more actual power to the attached load.
2.2 Exterior & Dimensions
Figure 2-1: SUINT1000XLCD
Exterior and Dimensions
Figure 2-2: SUINT2000XLCD / SUINT3000XLCD
Exterior and Dimensions
4