GGP ITALY Cruiser 430 Li 80 Serie Manual De Instrucciones página 112

J. Control lever: starts/stops the
motor and simultaneously engages/
disengages the cutting means Drive lever (if provided): the lever that engages the
K.
wheel drive and allows the machine to move forward.
L. Hatch for accessing the battery compartment
M. Safety key (Deactivation device): The key
enables / disables the machine electric circuit.
N. Battery charger: device used
to recharge the battery.
4. ASSEMBLY
The safety regulations to follow are
described in chap. 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some components of
the machine are not installed in the factory and have to be
assembled after unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for machine handling and its packaging,
always making use of suitable equipment. Do not
use the machine until all the indications provided
in the "ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the box.
4. Dispose of the box and packaging in
accordance with local regulations.
4.2 GRASS-CATCHER ASSEMBLY
Follow the indications provided in the instructions
provided with the grass catcher.
4.3 HANDLE ASSEMBLY
Assemble the handle as illustrated in (Fig. 3).
4.4 ASSEMBLY OF THE REAR DISCHARGE
GUARD PIN (FOR CR/CS SERIES ONLY)
Insert the pin as illustrated in (Fig. 4).
5. CONTROLS
5.1 SAFETY KEY (DEACTIVATION DEVICE)
The key found inside the battery compartment enables
/ disables the machine electric circuit (Fig. 5.A). Removing the key, the electric circuit is completely
deactivated to prevent uncontrolled use of the machine.
IMPORTANT Remove the safety key whenever
the machine is unused or left unattended.
5.2 CONTROL LEVER
The control lever starts/stops the motor and
simultaneously engages/disengages the cutting means.
The positions indicated correspond to:
1. Run. To start the motor, press the safety
button (fig. 6.A), pull one of the two
levers (fig. 6.B) and wait 2-3 seconds
for the motor to start running.
2. Ignition of the motor simultaneously
engages the cutting means.
3. Stop. The motor stops when both
levers (fig. 6.B) are released.
5.3 DRIVE ENGAGEMENT LEVER
This engages the wheel drive and allows
the machine to move forward.
1. Drive engaged. Push the lever
IMPORTANT The motor must always be
running with the drive disengaged.
IMPORTANT To prevent damage to
the transmission, do not pull the machine
backwards with the drive engaged.
5.4 CUTTING HEIGHT ADJUSTMENT
Lower or raise the chassis to cut the
grass at different heights.
Do this when the cutting means is stationary.
EN - 5
towards the handle for forward
movement (Fig. 7.A). The
lawnmower stops moving forward
when the lever is released.