GYS SPOT LIFT Manual De Instrucciones página 10

OPERATING INSTRUCTIONS
After connecting the jack's power supply and reviewing the precautions to be taken as well as the warnings, proceed
as follows:
The tool must be used only for vehicles with a weight inferior to 2.5T
2.5 t max.
It must not be used for vehicles equipped with a panoramic roof, that can be damaged during lifting.
Always have both hands on the handle when lifting and raising the fork.
Lifting:
• Before lifting, verify that the tyres' pressure is sufficient to maintain the vehicles'
balance.
• Check that the vehicle is blocked with the handbrake on. Check its efficacy.
• Position the jack so the fork is well adjusted on the sides of the wheel.
I • f using the lifting accessory for the lower body frame, check its positionning.
• Always check the good function of the lifting accessorries before lifting a vehicle.
• To raise the vehicle, action the pump by pressing on the pump's pedal on side A
• When the desired height is reached, release the pedal and secure the load by
placing the safety axis in the safety notch of the column (raise the safety cover).
• For extra safety, always place axle stands below the vehicle, in order to support
it.
• Press on the pump's pedal on side B so the load comes to rely on the safety axis.
Do not raise the jack above the maximum marker, to avoid reaching the end of the jack's course
(check picture below)
Lowering :
• Press the pump's pedal on side A to relase the safety axis.
• Remove the safety axis from its hole in the column
• Press the pump's pedal on side B to lower the vehicle to the ground or at the desired height
• Remove the jack from the vehicle only once the jack is completely lowered.
• The vehicle can then be moved.
In case of prolunged non use, lower the jack to the ground.
Never leave the load unattended while raised.
10
Hydropneumatic pump
SPOT LIFT
B
A
Tolérances générales Description
ISO 2768-F Mécanique
Ra (µm) Sciage: Ra 25
Safety
cover
Indice: MPF / Commentaire:
A -
Matière: (Gys) Masse: 96088.86 g
Surface:
Désignation:
SMART LIFT 3T
Produit: -
Nom du fichier CAO:
Ce document est la propriété de la société GYS et ne peut en aucun cas être transmis à quiconque sans son accord.
Maximum height marker, do not go further
EN
Jusqu'à 3 Jusqu'à 6 Jusqu'à 30 Jusqu'à 120 Jusqu'à 400
±0.05 ±0.05 ±0.1 ±0.15 ±0.2
Fraisage: Ra 3.2 Tournage: Ra 1.6 Casser les angles: 0.2 x0.2
The safety
axis
A
Plan de Contôle
Date modification: Modifié par:
30/04/2019
Traitement: (Code ST Gys) Etabli par: Mickaël TEXIER
Non Date: 22/03/2013
Statut: Format :
PROTOTYPE
Études
Echelle:
Indice:
052864
13_01206 MECANIQUE
B
Jusqu'à 1000
±0.3
mickael
A4
1:10
Feuille:
A 1/1