Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks STG310 Manual Del Operario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
When you remove the machine from the box, the three
poles of the machine are connected by an electrical cord as
shown.
1. Push in the release button located on the middle shaft.
2. Align the release button with the positioning hole on the
upper shaft and slide the two shafts together until the
button locks into the positioning hole.
3. Repeat above procedure to connect middle shaft to lower
shaft.
3.4
ATTACH THE AUXILIARY
HANDLE
Figure 5-6.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
3.5

INSTALL THE BATTERY PACK

Figure 7.
WARNING
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6

REMOVE THE BATTERY PACK

Figure 7.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
NOTE
English
4.1

START THE MACHINE

Figure 8.
1. Push the lock-out button and pull the trigger.
4.2

STOP THE MACHINE

Figure 8.
1. Release the trigger to stop the machine.
4.3

OPERATION TIPS

Figure 9.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
Keep the machine connected to the correctly worn
harness.
Keep a firm hold with the two hands on the machine
while you operate the machine.
Cut tall grass from the top down.
If grass winds around the trimmer head:
Remove the battery pack.
Remove the grass.
4.4

CUTTING TIPS

Figure 10.
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
Move the machine from right to left to prevent thrown
debris toward the operator.
Do not cut in the dangerous area.
Do not force the trimmer head into uncut grass.
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
4.5
ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 8.
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
5
WARNING
WARNING
NOTE
EN
Tabla de contenido
loading

Tabla de contenido