Panasonic TY-ST85P12 Instrucciones De Instalación página 4

Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to light
or heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is extremely
soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a dry cloth. Do
not use cleaners such as benzene, thinner or furniture wax because they may cause paint peeling. (For
information on cleaning the display unit, see the display unit's instruction manual. If using a chemically-
treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the pedestal. Do
not allow long-term contact with rubber, vinyl products or the like. (Doing so will cause deterioration.)
4) The panel of the plasma display is made of glass. Do not apply a strong force to it or subject it to
impact.
Points to note during installation
● In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in any
of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
● Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily accessible.
● Provide adequate ventilation so that the temperature around the display does not rise above 40 °C
(104 °F). If there is insufficient movement of the air inside display, heat may build up inside the display,
and fire may result.
● Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
● Spread a soft blanket or cloth over the floor so that the stand and floor will not be marked or scratched
during the assembly and installation work.
● Perform the assembly and installation work on a flat and level surface, and follow the assembly and
installation work instructions.
● When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
● Take sufficient care to ensure safety around you when performing the assembly and installation work or
while moving about during the course of the work.
● Do not use any components other than the packaged ones.
● Be sure to read and observe the "Precautions with regard to setting up".
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
15