Panasonic TY-ST85P12 Instrucciones De Instalación página 11

Assembly
5. Wiring the equipment to be connected
For details on how to install the equipment to be connected with the display or adding more equipment, refer to the
operating instructions of the plasma display and the operating instructions of the equipment concerned.
For details on how to wire the equipment to be connected to the plasma display, refer to the operating instructions of
the plasma display.
1. Insert the 6 clamps  into the rear panel of the
right support  .
2. Mount the clamp  onto the stand base  using
the clamp mounting screw  .
3. If the equipment to be connected (such as an AV amplifier
and DVD recorder) is to be installed at the same time for
use, connect the plasma display wires first.
4. When wiring to connecting
equipment, pull wiring to the rear,
using the mounted clamps.
The support  side is for the cords
from the connecting equipment, and
the stand base  side is used for the
LAN cable.
When using the LAN cable
Refer to the operating instructions
of the plasma display, and use the
clamp provided with the plasma
display and the clamp of the stand
base  .
(For the wiring, refer to the dashed
line in the figure.)
Caution
•
If using LAN cable to connect
plasma display, connect the LAN
cable so it is separate from other
cables (this does not include the
power cord).
22
Clamp mounting screw 
(LAN cable)
Cords for connecting
equipment
Clamp 
Clamp 
Clamp provided with the
plasma display
Power cord