Rear Panel - Tripp-Lite NetDirector B024-HU08 Guia De Inicio Rapido

Introduction
Key Component Description
Firmware During normal operation and while performing a firmware upgrade, the
C
Upgrade switch should be in the NORMAL position. If a firmware upgrade operation
Recovery does not complete successfully, this switch is used to perform a firmware
Switch upgrade recovery (for details, see Owner's Manual section 13.6
Firmware Upgrade Recovery).
Audio Port Connect speakers to this port (optional). The speakers plugged into this
D
connector have priority over those plugged into the rear panel.
Firmware This port is used to upgrade the firmware on the KVM switch. Connect the
E
Upgrade Port included Firmware Upgrade Cable to this port.
USB 2.0 USB 2.0 peripherals (printers, scanners, etc.) can be connected to the
F
Hub port (a user-supplied power adapter may be required).
Note: The USB 2.0 hub cannot be accessed through the switch by computers on
the second or third level or a cascaded installation.
Reset Switch Pressing this switch performs a system reset. When the system is reset,
G
the unit beeps and the port LEDs flash in succession until the reset is
complete. After the reset is complete, you can log in again.
H
Power LED Illuminates to indicate the switch is powered and ready to operate.

Rear Panel

(Model B024-HU08 shown)
I J
K L
Key Component Description
I
Power Jack The power adapter cable connects here.
Console Port The cables from the console HDMI monitor, USB keyboard, USB
J
Selection mouse and speakers connect here. Each connector is marked with an
appropriate icon to indicate the connector type.
Grounding
K
Connect a grounding wire to ground the switch (optional).
Terminal
USB 2.0 USB 2.0 peripherals (printers, scanners, etc.) can be connected to the
L
Hub port.
Note: The USB 2.0 hub cannot be accessed through the switch by computers on
the second or third level of a cascaded installation.
KVM Port Cables that link the switch to the computers connect here. Each KVM port
M
Selection selection includes a speaker jack, a USB Type-B connector and an HDMI
connector with screw lock.
M
5