Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future reference and
for local electrical inspector's use, if required.
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install compactor.
Failure to do so can result in back or other injury.
IMPORTANT: Begin in the room where the compactor will be
located.
1. Remove compactor from shipping carton.
2. Remove all packaging materials such as tape and shipping
pads.
3. Use a mild detergent and warm water to remove waxy
residue caused by shipping material.
4. Dry thoroughly with a soft cloth. For more information, see
"Cleaning."
5. Be sure the power cord is attached to the cord clip on the
rear of the compactor.
A
6. Place the 2 corner posts from the carton on the floor near
the compactor.
7. Press the foot pedal to open the compactor drawer and
remove any shipping materials or other items from the
drawer.
NOTE: Do not remove the compactor bag.
8. Grasp sides of drawer and lift drawer out of compactor.
Place the drawer on the 2 corner posts.
INSTALLATION INSTRUCTIONS
A. Cord clip
9. Place the other 2 corner posts on the floor to the side of the
compactor.
10. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts.
11. Remove the shipping base from the bottom of the
compactor.
A
A. Leveling legs
B. Shipping base
Location Requirements
Product dimensions
¹⁄₈
34
"
(86.7 cm)
(38.1 cm)
B
24"
15"
(61 cm)
5
Capítulos
Tabla de contenido
Solución de problemas
