Panasonic TY-ST85PF12 Instrucciones De Instalación página 12

5. Anchoring the floor stand
Move the floor stand to the position where the user wants it to
be installed.
Anchoring with adjusters
Move the unit to the desired place and anchor it with the
adjusters.
Check whether the plasma display is leaning. If it is, use the
adjusters to set it upright.
Adjustment procedure
 Loosen the adjuster anchoring nuts.
 Use the adjusters to change the height so that the
inclination is adjusted.
 Tighten up the adjuster anchoring nuts to fix them in
place.
6. Toppling prevention
Anchoring to wall or post by wire
Pass commonly available metal wire (with breaking
strength of at least 7.8 kN) through holes in display
mounting fixture  and anchor to a strong wall, post,
etc., leaving no slackness in the wire.
Note
•
Components for toppling prevention are not included with
the product.
Use a commonly available product (with breaking strength
of at least 7.8 kN) that is suitable for the way your home is
built.
Removing the plasma display
Caution
•
Always ask a qualified professional to move the plasma display or remove it.
•
Because the display is heavy, handle it carefully by the use of lifting equipment (machine).
1. Remove the toppling prevention system and loosen the adjuster to release unit from its anchored status.
2. Remove wiring to connecting devices, and then remove grounding plate.
3. Remove the 2 screws for securing unit starting from the upper left side of the left and right display
mounting fixtures.
4. With the plasma display held in suspension, pull it forward to remove it.
Adjuster
23