How To Install The Product; Install The Hardware; How To Install A Lock To The Security Slot - Axis P1367 Guia De Instalacion

How to install the product

Install the hardware

NO TICE NO NO TICE TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use. Make sure that the midspan is properly
grounded. For information about regulatory requirements, see Regulatory information 4.
Note
• Make sure that the material is strong enough to support the weight of the camera.
1. Prepare the wall or ceiling for installation of the stand. Use the stand as a template and
mark the holes before drilling.
2. Route the network cable through the wall or ceiling. Leave approximately 30 cm (11.8
in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Install the stand on the wall or ceiling and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
5. Install the camera on the stand and tighten the tripod screw.
6. Connect all cables to the camera.
7. Aim the camera in the right direction and use the supplied Allen key to tighten the
ball joint.

How to install a lock to the security slot

To secure the camera to the stand a lock with a cable could be attached to the security slot of
the camera.
To install the lock:
1. Cut a hole in the label covering the security slot.
2. Install the anchor to the security slot.
3. Attach the cable to the stand, then connect the lock head to the anchor.
AXIS P1367 Network Camera
13
EN