Note:
In the event of changing batteries of the units, ensure the batteries do not spring free from the contacts.
Always wait at least 1 minute after removing the batteries before reinserting, otherwise start up and
transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1.
User shall remove all the batteries from the Weather Station and transmitters, and wait 60 seconds.
2.
Insert the batteries in the first transmitter.
3.
Within 2 minutes of powering up the first transmitter, insert the batteries in the weather station. Once
the batteries are in place, all segments of the LCD will light up briefly and a short signal tine will sound.
Following the indoor temperature/humidity and the time as 0:00 will be displayed. If these information
are not displayed on the LCD after 60 seconds, remove the batteries from both units and wait for at
least 60 seconds before reinserting them.
4.
The outdoor temperature and humidity data from the first transmitter (channel 1) should then be
displayed on the weather station. Also, the signal reception icon will be displayed. If this does not
happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1.
5.
Insert the batteries in the second transmitter as soon as the outdoor temperature and humidity readings
from the first transmitter are displayed on the weather station.
Note : User shall insert the batteries into the second transmitter within 45 seconds after the weather
station displays the information of the first transmitter.
6.
The outdoor temperature and humidity from the second transmitter and the "channel 2" icon should
45