Medion LIFE X14330 Guía Rápida página 94

3.7.8. Satellite
Make sure that your satellite connection is connected to the LNB connection.
 Select the required type of satellite (
.
OK
 Select the desired provider and press
.
LITE
If you initially selected
DEUTSCHLAND
search, select
 Then select the antenna type
Press the  button to continue. Under
tions are available:
TUNER
BAND FREQUENCY
USER DEFINED
 If necessary, you can now configure satellite settings. Otherwise, skip DVBS configuration set-
ting by pressing the  button.
 Under
SELECT SATELLITE
SATELLITE STATUS
LNB POWER
LNB FREQUENCY
DISEQC SET
TONE 22 KHZ
TONE BURST
TRANSPONDER
SIGNAL QUALITY
SIGNAL LEVEL
SATELLITE STATUS
POSITION
LNB FREQUENCY
TRANSPONDER
PREFERRED SATELLITE
. This option is only available under
OK
PREFERRED SATELLITE
, an LNB search is performed before the channel search. To start the LNB
or . The LNB search is started.
and press
SCAN OK
,
UNIVERSAL SINGLECABLE
SINGLECABLE
DVBS configuration setting
Select the desired
Select the band frequency
You can set a band frequency of your choice here using the virtual
keyboard. This option can only be edited if you have previously se-
lected
USER DEFINED
, you can, if necessary, configure settings for the following options:
Satellite Setup
UNIVERSAL
Activate/deactivate the satellite status. When deactivated, LNB set-
tings can be changed or a search started.
Set the LNB power here.
You can set the centre frequency here.
If you have connected multiple LNBs or a DiSEqC switch to your sat-
ellite antenna, set the desired LNB here.
Set the audio here, if necessary.
If your satellite system requires a tone burst, you can set it to
or here
A B
Select the transponder on which the search will be started.
The signal quality is shown in per cent. Settings here cannot be
changed.
The signal strength is shown in per cent. Settings here cannot be
changed.
Satellite Setup
SINGLECABLE / JESS SINGLECABLE
Activate/deactivate the satellite status. When deactivated, LNB set-
tings can be changed or a search started.
Select the desired position
You can set the centre frequency here.
Select the transponder on which the search will be started.
or
GENERAL SATELLITE
and the provider
or
JESS SINGLECABLE
and
JESS SINGLECABLE
.
USER BAND 1  8
1210, 1284, 1400
under
BAND FREQUENCY
or here
A B
) and press
PREFERRED SATEL
FAST SCAN
and press .
OK
the following op-
or .
USER DEFINED
.
BURST
EN
13