Scheppach MFH3300-4P Manual De Instrucciones página 45

Fault Possible cause
Machine does not
• Air filter is contaminated.
start.
• Fuel filter is blocked.
• Lack of fuel supply.
• Fault in the fuel line.
• Starting device is faulty.
• Engine stalled.
• Spark plug cap not attached.
• No spark.
• Engine faulty.
• Carburetor faulty
Machine starts but
• Wrong carburetor setting (idle speed).
stops again.
Engine starts but the
• Cutting tool blocked.
cutting tool stops.
• Internal fault (drive shaft, gearbox).
• Clutch faulty.
Machine works with
• Carburetor set up incorrectly.
interruptions (sputter-
• Spark plug is sooty.
ing).
• On/off switch faulty.
Smoke is generated.
• Wrong fuel mix.
• Carburetor set up incorrectly.
Machine does not
• Machine is overloaded.
work at full power.
• Air filter is contaminated.
• Carburetor set up incorrectly.
• Silencer is blocked.
Brush cutter does not
• Blades are blunt or damaged.
work at full power.
• Cut material is too high (machine
overload).
Grass trimmer does
• Cutting line too short or damaged.
not work at full power.
• Machine is overloaded because the
grass is too high.
Cutting line cannot be
• Spool empty.
fed through.
Pole saw does not
• Chain tension too high.
saw, it plucks or
• Chain blunt.
vibrates.
• Chain attached incorrectly.
• Chain worn.
Saw chain becomes
• No oil in the tank.
hot or saw chain lubri-
• Oil line blocked.
cation does not work.
• Chain tension too high.
• Chain blunt.
 www.scheppach.com /  [email protected] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
• Clean/replace the air filter.
• Clean or renew the fuel filter.
• Re­fuel.
• Check the fuel line for kinks or damage.
• Contact the service centre.
• Remove the spark plug, clean and dry it; then
pull the starter rope several times; re­fix the
spark plug.
• Check the correct position of the spark plug cap.
• Clean the spark plug or replace it, if applicable.
• Check the ignition cable for damage.
• Contact the service centre.
• Contact the service centre.
• Turn off engine and remove object.
• Contact the service centre.
• Contact the service centre.
• Contact the service centre.
• Clean the spark plug or replace it.
• Contact the service centre.
• Use two­stroke mixture at a ratio of 40:1.
• Contact the service centre.
• Do not use force during mowing/trimming.
• Clean the air filter or replace it.
• Contact the service centre.
• Check the exhaust.
• Sharpen or replace blades.
• Cut the grass in phases.
• Feed more cutting line through or replace it.
• Cut the grass in phases.
• Replace spool.
• Check and reset chain tension.
• Have the chain sharpened or replace it.
• Re­attach the chain.
• Replace the chain.
• Refill oil.
• Clean the oil line.
• Set the chain tension.
• Have the chain sharpened or replace it.
GB | 45