Idiomas disponibles
Idiomas disponibles
INSTANT SETUP
Getting Started
1. Ensure all power is turned off on your mixer. To totally ensure
this, the AC cable should not be connected to the unit.
2. All faders and level controls should be set at the lowest
level and all channels switched off to ensure no sound is
inadvertently sent through the outputs when the device is
switched on. All levels can be altered to acceptable degrees
after the device is turned on.
3. Plug all necessary instruments and equipment into the
device's various inputs as required. This may include line
signal devices, such as keyboards and drum machines, as
well as microphones and/or guitars, keyboards, etc.
4. Plug any necessary equipment into the device's various
outputs. This could include amplifiers and speakers,
monitors, signal processors, and/or recording devices.
5. Plug the supplied AC power supply into the inlet on the
rear of the device and then into a power outlet of a suitable
voltage.
6. Turn the power switch on and follow the channel setup
instructions to get the most out of your equipment.
2
All manuals and user guides at all-guides.com
Channel Setup
1. To ensure the correct audio level of the input channel is
selected, each of the level input controls of the Mixer should
be turned counterclockwise as far as they will turn (which
should be the -∞ mark).
2. No input other than the one being set should have any
device plugged in. This will ensure the purest signal is used
when setting channels.
3. Ensure the channel has a signal sent to it similar to the
signal that will be sent when in common use. For example, if
the channel is using a microphone, then you should speak or
sing at the same level the performer normally would during a
performance; if a guitar is plugged into the channel, then the
guitar should also be strummed as it normally would be (and
so on). This ensures levels are completely accurate and
avoids having to reset them later.
4. Set the gain so the level meter indicates the audio level is
around 0 dB.
5. This channel is now ready to be used; you can stop making
the audio signal.
6. You can repeat the same process for other channels.
AM55/AM85/AM105/AM105FX/AM125/AM125FX
Capítulos
