Environmental Protection; Intended Use - Ryobi EWS1150RS Traducción De Las Instrucciones Originales

special cuts such as "plunge cuts" and "compound
cuts". Raise lower guard by retracting handle and as
soon as blade enters the material, the lower guard
must be released. For all other sawing, the lower guard
should operate automatically.
■ Always observe that the lower guard is covering the
blade before placing saw down on bench or floor.
An unprotected, coasting blade will cause the saw to
walk backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop after
switch is released.
WARNING
■ Wear eye and ear protection.
■ Wear dust mask.
■ Do not use any abrasive wheels.
■ Avoid overheating the blade tips. Do not use dull or
damaged blades. Do not force the tool.
■ Only use saw blades recommended.
■ Do not use blades of larger or smaller diameter than
recommended.
■ Use only blades specified in this manual, complying
with EN 847-1.

INTENDED USE

■ Sawing and mitre cutting all types of wood.
Do not use for cutting metal or masonry.
MAINTENANCE
WARNING
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■ When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
■ Be sure to disconnect the tool from the power supply
before attaching or removing the saw blade. Clean the
tool and guarding system with clean cloths, or blow it
clean with compressed air.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■ Do not at any time let brake fluids, gasoline, petroleum-
2
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
■ Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
■ If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorized service
center to avoid risk. Contact authorized service center.
■ For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging
environmental-friendly recycling.
SYMBOLS
Safety alert
Wood
Do not cut metals
Width of cut
Blade teeth
Class II tool, double insulation
CE conformity
EurAsian Conformity Mark.
Please read the instructions carefully
before starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
English
should be sorted for