Preselecting The Speed - Flex XC3401VRG Manual De Instrucciones

Polisher XC 3401 VRG
Note
Following a power failure, the switched on
power tool does not restart.

Preselecting the speed

– To set the operating speed, move the
dial (9) to the required value.
– Gently press the switch (7) to accelerate
the power tool up to the preselected
speed.
Note
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attach or change tools
1. Pull out the mains plug.
2. Firmly press polishing material, centred
on the eye, onto the Velcro pad (11).
Use undamaged polishing tools only.
3. Insert the mains plug into the socket.
4. Switch on the polisher (without engaging
it) and run the polisher for approx.
30 seconds. Check for imbalances and
vibrations.
5. Switch off the polisher.
Operating instructions
Caution!
When the polisher is switched off,
the polishing tool continues running briefly.
Note
Following a tool change (e. g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel (9) until the vibrations have
been reduced.
– Switch on the machine before placing it
on the surface which is to be polished
and run the polisher up to the set speed.
– Applying light contact pressure, move
the polisher in circular, overlapping
movements on the surface which is to
be polished in order to obtain a good
polishing finish and to ensure that the
tool has a long service life.
– On sensitive surfaces (e.g. car
paintwork) do not work aggressively
but work at slow speeds applying low
contact pressure.
For further information on the manu-
facturer's products go to www.flex-tools.de.
17