Uline SANITARE H-2665 Manual Del Usuario página 6

BRUSH ROLL
The brush roll turns as it sweeps and combs the carpet
nap. Remove hair and threads from the brush roll so
it continues brushing the carpet. To maintain the most
efficient cleaning, the bristles must touch the carpet.
To test the bristle length, hold a ruler against the
underneath side of the vacuum. If the bristles no longer
touch the ruler, replace the brush roll.
BRUSH ROLL BELT
The brush roll belt turns the brush roll to agitate, sweep,
and comb the carpet nap. Check the belt regularly
to be sure it is in good condition. Replace the belt if it
stretches, cracks or loses tension. Cut away any hair or
threads wound around the brush roll or the belt pulley
because the buildup could cause the belt to rotate
unevenly.
NOTE: To check the belt, while the unit is
turned on turn the unit upside down and apply
pressure with foot to the brush roll. If the brush
roll stops replace the belt. (See Figure 18)
Figure 18
HOW TO REPLACE BRUSH ROLL BELT
CAUTION! Turn off the switch and unplug the
electrical cord before replacing belt. Belt
pulleys can become hot during normal use. To
prevent injury, avoid touching the motor shaft
when changing the belt.
NOTE: The carpet height adjustment has to be
in the lowest or highest position to remove or
reinstall the hood.
1. Using the handle release pedal, lower handle to
floor to change belt. (See Figure 19)
2. Remove the three screws from the top of the vacuum.
Lift hood to remove. (See Figure 19)
Figure 19
Screws
PAGE 6 OF 30
MAINTENANCE CONTINUED
3. Lift left end cap of brush roll. Remove old belt and
4. Place new brush roll belt around motor shaft.
5. Place belt around brush roll pulley. (See Figure 22)
6. Align left brush roll end cap with base. Push left brush
7.
8. Rotate brush roll by hand two full rotations to
Handle
Release
Pedal
9. Place hood back on vacuum. Make sure hood front
discard. Remove and discard old brush roll if bristles
are worn. (See Figure 20)
Figure 20
Brush
Roll
(See Figure 21)
Figure 21
roll end cap securely into place. (See Figure 22)
Push right brush roll end cap into base until it snaps
into place. (See Figure 22)
Figure 22
Left Brush
Roll End
Cap
properly position belt. (See Figure 23)
Figure 23
is behind furniture guard. Replace three screws.
Motor
Shaft
Brush
Roll Belt
Right Brush
Roll End Cap
Brush Roll Pulley
1020 IH-2665