Uline H-2268 Solución De Problemas
  1. Manuales
  2. Marcas
  3. Uline Manuales
  4. Aspiradoras
  5. SANITAIRE H-2268
  6. Solución de problemas
Uline H-2268 Solución De Problemas

Uline H-2268 Solución De Problemas

Ocultar thumbs Ver también para H-2268:
1
2
3
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-2268
SANITAIRE
UPRIGHT VACUUM
®
OPERATING ISSUE
Belts continue to break.
If there is little or no suction.
Vacuum turns off while in use.
Vacuum has a burning smell.
Brushes aren't turning.
PAGE 1 OF 3
1-800-295-5510
uline.com
TROUBLESHOOTING
1. The agitator bar should be positioned so the belt lines up
with the grooves on the bottom frame of the vacuum.
2. Ensure that vacuum is set to correct carpet height setting.
(See Instructions)
1. There may be a clog in the hose. Take the hose apart at the
top and bottom and remove the clog.
2. Clean or replace the HEPA filter assembly and/or pre-motor
filter.
3. Ensure that vacuum is set to correct carpet height setting.
(See Instructions)
4. Check suction control valve to ensure it is set correctly.
Can be set to Hose or Floor Cleaning.
1. The machine may turn off due to overheating.
2. Check to make sure nothing is caught on the brush roll and
check for clogs.
3. You will need to press the reset button to restart the brush.
1. The belt may be damaged or something may be caught in
the brush roll.
2. Check brush roll for obstruction.
3. Replace belt.
(See Instructions)
1. Check suction control valve to ensure that it is turned to
floor cleaning.
2. Make sure vacuum is lowered into cleaning position.
(Will not spin in upright storage position.)
Para Español, vea página 2.
Pour le français, consulter la page 3.
RECOMMENDATIONS
0321 TH-2268
loading

Manuales relacionados para Uline H-2268

Resumen de contenidos para Uline H-2268

  • Página 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-2268 1-800-295-5510 uline.com SANITAIRE UPRIGHT VACUUM ® TROUBLESHOOTING OPERATING ISSUE RECOMMENDATIONS Belts continue to break. 1. The agitator bar should be positioned so the belt lines up with the grooves on the bottom frame of the vacuum.
  • Página 2 H-2268 800-295-5510 uline.mx SANITAIRE ASPIRADORA ® VERTICAL SOLUCIÓN DE PROBLEMAS PROBLEMA DE FUNCIONAMIENTO RECOMENDACIONES La correa continúa rompiéndose. 1. La barra del agitador debería estar colocada de forma que la correa quede alineada con las ranuras ubicadas en el marco inferior de la aspiradora.
  • Página 3 H-2268 1-800-295-5510 uline.ca SANITAIRE – ASPIRATEUR VERTICAL DÉPANNAGE PROBLÈME RECOMMANDATIONS La courroie se rompt continuellement. 1. La barre de battage doit être positionnée de façon à ce que la courroie s'aligne avec les rainures du chassis inférieur de l'aspirateur. 2. Assurez-vous que l'aspirateur est réglé en fonction de l'épaisseur du tapis.