Factory Reset Procedure - Technoline WS 2816 Manual De Instrucciones

 If you wish to perform a FACTORY RESET, press the SET key to confirm and to
enter the FACTORY RESET PROCEDURE. SEE WARNINGS in the FACTORY
RESET section.

FACTORY RESET PROCEDURE

WARNING:
Performing a factory reset will erase all MIN/MAX values and weather data stored
in the display's internal memory and return the weather units settings back to the factory
defaults. If you have not yet uploaded the data to the Heavy Weather Pro software, the
data will be lost.
If you do not wish to reset the display to factory defaults either:
 press the MIN/MAX key or the ALARM key, or
 simply wait until the SET mode times out and returns to the Mode 1 display
(normal mode).
To reset the display to factory defaults, follow the procedure below:
WARNING:
A factory reset will erase the connection between the display and the thermo-
hygro sensor and require the connection to be re-established.
 "rES oFF" will start flashing.
 Use the ▲UP ARROW key to turn "rES on".
 Press the SET key to confirm and a countdown timer will begin counting down from
"127" When the timer displays "dOnE", you must remove the batteries from the
display for 10 minutes. While the batteries are out of the display, also remove the
batteries from the thermo-hygro sensor.
 After waiting for 10 minutes, insert the batteries into the thermo-hygro sensor,
making sure to align the "+" symbol on the batteries with the markings on the
battery cover and inside the battery compartment.
 Within 2 minutes of inserting the batteries into the thermo-hygro sensor, insert the
batteries into the display, making sure to align the "+" symbol on the batteries with
the markings inside the battery compartment.
 Wait 5 minutes for the outdoor weather data to display. If any of the outdoor data
displays "--" after waiting for 5 minutes, follow the "Setting Up" Procedure near the
beginning of this manual included with the product.
53