Philips GC4820 Manual De Instrucciones página 18

EnGlish
18
Problem
The iron does not
produce steam.
The iron does not
produce steam.
The iron leaks.
Water leaks out of
the soleplate when I
fill it with water.
The shot-of-steam
function does not
work properly.
Flakes and impurities
come out of the
soleplate during
ironing.
Possible cause
When you use the iron in
cordless mode, it cools down
after a while. It needs to
reheat on the stand regularly.
The steam control is set to
the 'no steam' setting (0).
The water tank is empty.
The water tank is overfilled.
The steam control is set to a
steam setting (1-6) when you
fill the water tank.
You have used the shot-of-
steam function too often
within a very short period.
Hard tap water causes
flakes to develop inside the
soleplate.
Solution
Put the iron back onto the stand until the
temperature light goes out to indicate that the
iron is ready for use again.
Set the steam control to a steam setting (1-6).
Fill the water tank.
Do not fill the water tank beyond the MAX
indication.
Set the steam control to 0 (= no steam) when
you fill the water tank.
Put the iron back onto the stand until the
temperature light goes out to indicate that
the iron is ready for use again. Always set the
temperature dial to 3 or MAX when you
use the shot-of-steam function.
Use the shot-of-steam function repeatedly to
remove flakes and scale from the soleplate. We
advise you to use demineralised water if the tap
water in your area is too hard. You can also use
the Calc-Clean function.