Portfolio 16034 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
1. Connect the mounting bracket (EE), with
short machine screws (BB), to the outlet box.
Orient the mounting bracket (EE) so that the
raised center portion protrudes into the outlet
box. (See Fig. 1.)
Hardware Used
Short Machine
BB
Screws
Mounting
EE
Bracket
2. Attach extended arm sections (E) to center
section couplings (I) and secure with Allen set
screw (K), using Allen wrench (JJ). Note: While
attaching the arm sections the slack wire must
be pulled into the canopy (A) by gently pulling on
the wires (M) within the canopy marked with the
"PULL HERE" label (L). (See Fig. 2.)
Hardware Used
Allen
JJ
Wrench
3. Marking the mounting position of the arm support
standoffs (J): Remove the couplings (G) from the
standoffs (J) with the Allen Wrench (JJ) by
loosening the Allen setscrew (K). Screw standoffs
(J) onto arm section (E). Temporarily position fixture
in place on mounting bracket (See Fig. 1.) and
mark on the ceiling the location of the standoffs (J).
Drill 1/8" diameter holes into the ceiling at these
marked locations. (See Fig. 3.)
Hardware Used
Allen
JJ
Wrench
x 2
x 1
GND
x 1
x 1
1
Outlet Box
(Not Included)
BB
2
E
3
JJ
5
L
JJ
K
I
Ceiling
G
K
J
E
EE
M
A