Tripp-Lite B126-1A1 Manual Del Proprietário página 25

Extender/Splitter Daisy-Chain with
Remote/Repeater Installation
1
Make sure the HDMI source is powered OFF.
2
Connect the HDMI source to the INPUT port on the B126-004 using a
Tripp Lite P568-Series HDMI Cable.
3
Connect the LOCAL port on the B126-004 to the INPUT port on a
second B126-004 using the included 1 ft. HDMI daisy-chain cable.
4
Repeat step 3 if connecting a third B126-004.
5
Optional: Connect a local monitor to the LOCAL HDMI port of the last
B126-004 using a Tripp Lite P568-series HDMI cable.
6 Connect the external power supply to the first B126-004 in the
daisy-chain and plug it into a Tripp Lite Surge Protector, PDU or UPS.
The green RJ45 LEDs and the red Power LED on the B126-004 will
illuminate to indicate power is being received from the external power
supply.
7
Repeat step 6 for each additional B126-004 in the daisy chain.
8
Using Cat5e/6 cable, connect one of the RJ45 output ports on the local
unit to the RJ45 input port on the B126-110 remote/repeater unit.
9
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit using a Tripp Lite P568-Series HDMI Cable.
10
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green power LED
and the green RJ45 LEDs illuminate to indicate the unit is receiving
power.
Up to four units can be daisy-chained (three remote/repeaters and one
receiver). To connect additional remote/repeater units, proceed to step
11. To finish your installation with a B126-1A0 or B126-1A0-WP-1 remote
receiver unit, proceed to step 15.
17-07-081-933731.indb 25
(B126-004 only)
25
8/2/2017 8:57:27 AM