Tripp-Lite B126-1A1 Manual Del Proprietário página 11

Extender Kit with Remote/Repeater Installation
4
Connect the external power supply to the local unit and plug it into a
Tripp Lite Surge Protector, PDU or UPS. The green LED illuminates to
indicate the unit is receiving power from the external power supply.
5
Using Cat5e/6 cable, connect the RJ45 port on the local unit to the
RJ45 INPUT port on the B126-110 remote/repeater unit.
6
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit using a Tripp Lite P568-Series HDMI Cable.
7
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green power LED
and the green RJ45 LEDs illuminate to indicate the unit is receiving
power.
Up to four units can be daisy-chained (three remote/repeaters and one
receiver). To connect additional remote/repeater units, proceed to step 8.
To finish your installation with the B126-1A1 or B126-1A1-WP remote
receiver unit, proceed to step 12.
8
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first
remote/repeater unit to the RJ45 INPUT port on a second remote/
repeater unit.
9
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit you just added using a Tripp Lite P568-Series HDMI Cable.
10
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green power LED
and the green RJ45 LEDs illuminate to indicate the unit is receiving
power.
11
To add a third remote/repeater unit, repeat steps 8 through 10.
To finish your installation with the B126-1A1 or B126-1A1-WP remote
receiver unit, proceed to step 12.
17-07-081-933731.indb 11
11
8/2/2017 8:57:24 AM