Tripp-Lite B126-1A1 Manual Del Proprietário página 18

Extender/Splitter with Remote/Repeater Installation
10
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green power LED
and the green RJ45 LEDs illuminate to indicate the unit is receiving
power.
11
To add a third remote/repeater unit, repeat steps 8 through 10.
To finish your installation with a B126-1A0 or B126-1A0-WP-1 remote
receiver unit, proceed to step 12.
12
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last remote/
repeater unit to the RJ45 INPUT port on a B126-1A0 or B126-1A0-WP-1
remote receiver unit.
13
Connect a monitor to the HDMI OUTPUT port on the remote receiver unit
using a Tripp Lite P568-Series HDMI Cable.
14
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Protector, PDU or UPS. The green LED
illuminates to indicate the unit is receiving power from the external
power supply. The orange LED illuminates to indicate the unit is
connected to a powered ON remote/repeater unit.
15
Repeat steps 5 through 14 for each additional RJ45 output port on the
local transmitter unit.
16
Turn on the power to the HDMI source. The orange RJ45 LEDs on the
local unit illuminate to indicate a signal is being received from the
source.
17
If necessary, use the Equalization control on the remote/repeater unit(s)
and remote receiver unit to adjust the video image.
Note: An improper Equalization setting can cause the monitor not to display a
picture at all. Try each Equalization setting until an acceptable picture is displayed.
17-07-081-933731.indb 18
18
8/2/2017 8:57:25 AM