General; Functions And Settings - Parker SensoControl SCE-020 Instrucciones Para El Manejo

1.0

General

The SCE series of panel instruments were developed for use in
modern measurement technologies. All typical input signals can be
used. They are specifically designed to complement
SensoControl equipment range and are distinguished by ease of
operation. The unit can be attached to the illuminated surface using
the tape supplied. The measurement value can be exactly read on
the four-digit, 13 mm-high LED indicator. The decimal point can be
selected freely. The current supply is variable from 11 . . 30 VDC. The
communication with corresponding periphery devices (the control
signal of a machine) is made possible through an analog output
signal and expandable with an optional serial interface RS232 and
relay contact, respectively. The digital data transfer to a PC is
possible as well as setting limit values to a relay contact.
A separate version is available to detect frequency signals.
Measurement of rotational speed and flowrate based on a frequency
input can be very easily done. The desired unit for each parameter
can be set on the illuminated front panel.
Please read the operating manual carefully in order to avoid
errors and personal injury or damage to the machine.
2.0

Functions and settings

The input signals are configured at the rear connecting strip. The
analog output is programmed according to the configured input
signals.
Input signal
0 . . 20 mA
4 . . 20 mA
0 . . 10 V
0 . . 8 kHz
The decimal places, indicator range (zero and full-scale), limit
values (max/min) and the interface settings (baud rate, scanning
rate) can be entered in the configuration menu.
Output signal
0 . . 20 mA
4 . . 20 mA
0 . . 20 mA
No output signal
- 2 -
the