brondell SWASH BL97 Manual Del Propietário página 23

OPERATING THE SWASH
Special Mode Operations
Activating / Deactivating Nightlight
The Nightlight is activated at the factory by default.
1. To deactivate the Nightlight, touch and hold "+" for four seconds.
This function cannot be performed while sitting on the seat.
2. To activate the Nightlight, touch and hold "+" for four seconds.
This function cannot be performed while sitting on the seat.
Sleep Mode
In Sleep Mode, the Swash essentially powers down. The Nightlight, the seat
heater and the water heater will turn off.
1. To activate Sleep Mode, touch and hold Stop button on the Auxiliary
Control for four seconds. The unit will power down.
2. To awaken the Swash from Sleep Mode, touch the Stop, Front,
or Strong button on the Auxiliary Control.
Factory Default Reset
It is possible to reset the Swash to Factory Default settings.
To reset the Factory Default settings, touch and hold the Stop button on
the Auxiliary Control for ten seconds. A beep will sound at two seconds
indicating the beginning of the reset process and another beep will sound at
four seconds indicating the reset is activated.
Resetting the seat to Factory Default does not change personalized
programming on the remote control. To reset the remote control to Factory
Default settings, open the battery compartment and remove the batteries.
Replace after 1 minute.
Automatic Tank Draining
1. To prevent stagnation, water in the warm water storage tank can be set to
drain and refill itself if the seat hasn't been used in 48 hours.
2. To program this feature, touch Stop and Water Temp at the same time and
hold for four seconds.
21